Holster
Cinch Tool
Gauge
Calibration Gauge
Pouch
Sizes:
1/2" (12.7 mm)
3/4" (19.1 mm)
Watts Manual Cinch Tool is designed for use with Heating PEX tubing and
CinchClamp connections.
Specifications
Connections shall use Watts cinch fittings and Heating PEX cross-linked
polyethylene pipe.
Installation Parameters
All CinchClamps must be installed using a Watts Cinch Tool and in
accordance with all installation guidelines.
– Make sure the tubing has a clean, square cut end.
– Slide the CinchClamp over the tubing.
– Insert fitting and position CinchClamp, allowing for approximately
1/8" clearance between clamp and fitting.
– Position the open jaws of the Cinch Tool over the tabs of the
CinchClamp and squeeze. Tool will release when cinch is complete.
If connections are made in temperatures below 30.0°F
(-1.1ºC), caution must be taken to cinch slowly, allowing
the Heating PEX to form a proper seal against the barb.
Do not use the Cinch Tool to remove CinchClamps.
This will cause damage to the tool, resulting in
improper connections.
Manual Cinch Tool
√
DesCriPTion
orDer#
Manual Cinch Tool (1/2" (12.7 mm) - 3/4" (19.1 mm) PEX)
0955155
ES-Manual-Cinch-Tool
– Watts CinchClamps are manufactured in
accordance with American Society for Testing
and Materials (ASTM) F-2098.
– Watts fittings are manufactured in
accordance with American Society for Testing
and Materials (ASTM) F-1807, F-2159,
and F-2434.
– Only for use with Heating PEX manufactured to ASTM
F-876/F-877.
Standards
For Residential or Commercial Radiant Heating and Snow Melt Applications
Job Name –––––––––––––––––––––––––––––––––––––––––––
Contractor ––––––––––––––––––––––––––––––––––––––––––––
Job Location –––––––––––––––––––––––––––––––––––––––––
Approval –––––––––––––––––––––––––––––––––––––––––––––
Engineer –––––––––––––––––––––––––––––––––––––––––––––
Contractor’s P.O. No. –––––––––––––––––––––––––––––––––––
Approval –––––––––––––––––––––––––––––––––––––––––––––
Representative ––––––––––––––––––––––––––––––––––––––––
Manual Cinch Tool with work pouch and calibration gauge. Calibration gauge
is located in side pouch.
Watts product specifications in U.S. customary units and metric are approximate and are provided for reference only. For precise measurements,
please contact Watts Technical Service. Watts reserves the right to change or modify product design, construction, specifications, or materials
without prior notice and without incurring any obligation to make such changes and modifications on Watts products previously or subsequently sold.
!
CAUTION
This Engineering Sheet is not intended to provide full installation
instructions and safety information. In order to avoid property
damage or injury, please refer to the complete installation manual
and product safety information provided with the product.
