Calibration
Do not use the Cinch Tool if it has been damaged,
as this may result in an improper cinch.
After repeated use of the Cinch Tool, it may require
calibration. For convenience, a calibration gauge is
provided in the tool pouch. Follow these steps when
calibrating a Watts manual Cinch Tool.
1. Insert the calibration gauge into the tool as shown. Ratchet the Cinch
Tool to the closed position and hold. Use the calibration gauge to
determine the jaw gap. Ideally, the jaw gap should be between 0.8mm
and 1.2mm. If the 1.2 mm side of the gauge slides into the gap, then
the jaw space is too large. If the 0.8 mm side of the gauge can not
slide into the gap, then the jaw space is too narrow.
2. To adjust the jaw gap, turn the Cinch Tool on its side and locate the
Phillips screw positioned on the ratchet arm. Use a standard Phillips
screwdriver to loosen the screw and to adjust the ratchet arm position.
Turning the arm left or right will change the jaw gap. Tighten screw
when desired jaw gap is reached.
Gauge
Adjustment screw
ES-Manual-Cinch-Tool
1145
©
2011
Watts
USA:
No. Andover, MA • Tel. (855) 699-2887 • Fax: (978) 794-1848 •
radiant.watts.com
Canada:
Burlington, ONT. • Tel. (905) 332-4090 • Fax: (905) 332-7068 •
radiant.watts.com
