Manual #199355
Rev 08/14/15
© 2015 Watts Premier
8716 West Ludlow Dr, Ste 1, Peoria, AZ 85381 • Tel. (800) 752-5582 • www.wattspremier.com
A Watts Water Technologies Company
Instructions:
PLEASE NOTE installation may vary depending on your
system, please review the attached diagrams for your unit. If
your unit is not shown, please contact customer service at
800-752-5582.
Preparation
Step 1 -
Turn off the hot and cold water angle stops
Step 2 -
Lift the handle on the reverse osmosis faucet to drain the
water from the system and storage tank. Note: If the tank
is equipped with a ball valve, close the valve to preserve
tank water
Adapt-a-valve Installation at Hot-Water
Angle Stop
Connect the adapt-a-valve as shown below
To Disconnect
How To Use the Quick Connect Fittings
To make a connection, the tube is simply pushed in by hand; the
unique patented John Guest collet locking system then holds the
tube firmly in place without deforming it or restricting flow.
Cut the Tube Square
Cut the tube square and remove burrs
and sharp edges. Ensure that the outside
diameter is free from score marks.
Push the tube into the
fitting and up to the
tube stop
Push Up to the Tube Stop
Pull to Check Secure
To disconnect, ensure that the
system is depressurized, push the
collet square against the fitting. With
the collet held in this position the
tube can be removed.
Pull on the tube
to check that it is
secure. Test the
system before use
Push in collet and remove tube
EXISTING HOT-WATER ANGLE STOP
WHITE WASHER
BRASS ADAPTER
BRASS ADAPTER
EXISTING LINE TO FAUCET
PLASTIC ADAPT-A-VALVE & COLLET
PLASTIC ADAPT-A-VALVE & COLLET
EXISTING FAUCET CONNECTION
EXISTING LINE TO HOT-WATER
ANGLE STOP
DO NOT USE ANY TEFLON
TAPE AT CONNECTIONS
DO NOT USE ANY TEFLON
TAPE AT CONNECTIONS
Tools Needed
•
5/8" Open-ended wrench or adjustable wrench
•
Knife or Scissors
•
Phillips screwdriver / screw gun
•
Channel Lock
Checklist
_____
Reverse osmosis system must be at least 25 feet (piping
distance) from the hot water heater
_____
For proper performance and pump life, make sure you are
up to date with your filters and please verify the pressure
of the storage tank (as recommended by your operating
manual)
_____
Reverse osmosis system must use a single 25-50 GPD
membrane
_____
A non-switched outlet
