23
Visit our website at http://watt-age.globalhobby.com for information on other Wattage products
❑
Very carefully push the wing brace down firmly to
sandwich the wing between the brace and the wing mount.
☞
For maximum strength it's important to make sure that
all parts of the wing brace are adhered securely to the wing.
Also double-check that the wing mount is securely adhered
to the bottom of the wing.
❑
Remove the protective backing from each of the clear
strips.
❑
Carefully apply one strip over the entire length of each
fiberglass dowel. Rub the strips down firmly to make sure
they are secured firmly to the wing.
❑
Using a modeling knife and a ruler, cut out the two long clear strips from the decal sheet.
☞
Make the cuts inside the black outlines so it doesn't show when you adhere the strips to the wing.
❑
Tie two of the four bands together so you have two long
rubber bands.
❑
Secure the wing into place using the two long rubber
bands as shown.
☞
If you try to use a single rubber band it will stretch so
tightly that it will damage the wing.
❑
Set the wing assembly onto the fuselage. Remember, the front of the wing mount should be pushed against the back
edge of the cowling.
Step 4: Mounting the Wing
