Watson Industries, Inc.
ADS-C232-3AD Rev A 10/25/2017
17
This will bring up the following message:
2) To proceed type 'Y'. Stop this process by typing either ‘N’ or ‘Q’.
If ‘Y’ is pressed, each channel will come up one at a time.
For example:
3) Type 'Y' to output the channel, type 'N' to remove the channel.
After the last channel is listed, this message will appear:
4) To accept the new channels type 'N'. Typing a ‘Y’ with start the command sequence over.
Typing a ‘Q’ at any time in the sequence will quit without updating the channels.
Changes made will not change the non-volatile settings. To make these new settings the default
value, send a Quotation Mark (“).
5) Press the space bar after quitting or updating the new channels to restart the data flow.
Appendix B.3 List Output Channels
1) To list the current output channel selection, type ‘3’ at the main menu.
2) The sensor will show which channels are currently active.
Appendix B.4 Select Analog Attitude Full Scale Range
1) To update the scale factor for the analog Bank output, type ‘4’ at the main menu.
This will bring up the menu:
2) To change the Bank Angle setting. type ‘1’ at this menu.
This will bring up the menu:
TO SET FOR OUTPUT FOR ANY OF THE FOLLOWING DATA ITEMS, PRESS Y
TO AVOID ANY OF THE FOLLOWING DATA ITEMS, PRESS N
TO QUIT AND DISREGARD ANY OTHER DATA, PRESS Q
*** DO YOU WANT TO PROCEED? (Y/N/Q)
DO YOU WANT OUTPUT TIME SINCE RESET?
Y = GOBACK, N = INSTALL DATA & QUIT, Q = QUIT
DO YOU WANT TO TRY TO SET DATA AGAIN?
SELECT ATTITUDE FOR SCALE FACTOR UPDATE (OR 'Q' TO QUIT):
1 = ANALOG BANK ANGLE
2 = ANALOG ELEVATION ANGLE
