6
WATLOW DIN-A-MITE Style D User’s Manual
DIN-A-MITE
®
“D” Power Controller
WATLOW Electric Manufacturing Company
1241 Bundy Blvd. Winona, MN 55987 USA
Declares that the following products:
Designation:
DIN-A-MITE
®
“D” Power Control
Model Numbers:
DD10 – (02, 24, 48 or 60)(C
X
, K1, K2, K3, F
X
) – (0, 1, S)(followed by any 3 numbers or letters.) X =
any number 0-9, or E-RRL4CSSAAA48X (
X
= any number or letter) or E-RRL4CSSAA248E
Classification:
Power Control, Installation Category III, Pollution degree II, IP00
Rated Voltage:
24 to 600 V~ (ac), 50 or 60 Hz
Meets the essential requirements of the following European Union Directives by using the relevant standards show
below to indicate compliance.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326-1: 2013
Electrical equipment for measurement, control and laboratory use - EMC requirements
(Industrial Immunity, Class A
1,2,4
Emissions) Not for use in a Class B environment
without additional filtering.
EN 61000-4-2:2009
Electrostatic Discharge Immunity
EN 61000-4-3:2010
Radiated Field Immunity 10V/m 80 MHz- 1GHz, 3V/m 1.4GHz-2.7GHz
EN 61000-4-4:2012
Electrical Fast-Transient / Burst Immunity
EN 61000-4-5:2006
Surge Immunity (Reviewed to IEC 61000-4-5 2014)
EN 61000-4-6:2014
Conducted Immunity
EN 61000-4-11:2004
Voltage Dips, Short Interruptions and Voltage Variations
EN 61000-3-2:2009
Harmonic Current Emissions (Reviewed to IEC 61000-3-2 2014)
EN 61000-3-3:2013
Voltage Fluctuations and Flicker
3
≤
16A
EN 61000-3-11:2000
Voltage Fluctuations and Flicker
≤
75A with conditional connection
NOTES
1
Use of an external filter is required to comply with conducted emissions limits. See note 4 below.
2
A Line Impedance Stabilization Network (LISN) was used for conducted emissions measurements.
3
To comply with flicker requirements, command signal models FX will require a reduced source impedance. Cycle time
on ON/OFF models CX, and K1, K2, K3 may need to be up to 175 seconds at 16A or have a reduced
source impedance.
2006/95/EC Low-Voltage Directive
EN 50178:1997
Electronic equipment for use in power installations.
Per 2012/19/EU W.E.E.E Directive Please Recycle Properly.
Compliant with 2011/65/EU RoHS2 Directive
4
Required External EMI Filters for DIN-A-MITE with More Than 6 Amp Loads
An external ElectroMagnetic Interference (EMI) filter must be used in conjunction with the DIN-A- MITE for loads in
excess of six amperes (6A) at 150 to 250 KHz. Watlow has verified that a tank filter will suppress EMI created by SCR
power controllers to comply with the conducted emissions limits.
Declaration of Conformity
ISO 9001since 1996.
Thermal Devices, Inc. Mount Airy, Maryland USA www.thermaldevices.com
Thermal Devices, Inc. Mount Airy, Maryland USA www.thermaldevices.com