Once the bottom quarter (1/4) is wet, slowly immerse entire bag,
squeezing gently to remove air. If the bag “puffs up,” you are immers-
ing it too quickly.
• Once the bag has been immersed, remove from the water and rinse it
by pouring more distilled water over bag to remove any carbon fi nes
(dust).
Install Filter
Be sure carbon is evenly distributed within bag, then place bag in fi lter
housing
(fi g. D). Replace cover on housing and place lid on carafe.
Replace Filter
The fi lter should be replaced as inicated by fi lter status bar (every two to
three months). Replace more often should the distilled water begin to have
an unwanted taste or odor. Reset the fi lter status bar by pressing and hold-
ing the “Delay” button (fi g. A) for seven seconds. Discard fi rst gallon of
distilled water as it may contain small, harmless carbon fi nes. Order re-
placement fi lters from the outlet where you purchased your Purifi er.
USING THE COUNTERTOP PURIFIER
Operational maintenance and replacement requirements are essential for
this product to perform as advertised.
1. Set Purifi er on a dry, level, well-supported, stable surface.
2.
Rinse
and
fi ll kettle to “MAX” lines with approximately 1 gallon ordi-
nary
tap
water.
DO NOT
fi ll above “MAX” fi ll lines (fi g. D).
3. Replace kettle cover. Twist clockwise to lock. slide kettle into base unit
and press fi rmly to ensure kettle is properly placed (fi g. C).
4. Place carafe on base unit and plug power cord into a GROUNDED
120
VOLT
outlet.
5. Press the ”Start/Stop” button to turn Purifi er on (fi g. C). The “On”
light
will
illuminate.
6. After the cycle is complete (approximately four hours) the Purifi er turns
off automatically.
AFTER THE FAN MOTOR STOPS, WAIT AT
LEAST 30 MINUTES BEFORE REMOVING KETTLE COVER
.
8
Waterwise 8800 Purifi er Use & Care Guide
“MAX” Fill Lines
Kettle Lid
Kettle
Gasket
Kettle
Figure
D
