Clean Boiler
• Remove boiler by grasping handle and pulling it out of chassis (fig. C).
• Remove boiler cap by turning it counterclockwise (fig. D).
• Loosen steam baffle securing nut by turning counterclockwise and
remove steam baffle (fig. D).
• Wash inside of boiler with soap and water.
• Rinse thoroughly. Water should be drained through boiler spout.
IMPORTANT:
Wipe off all water deposits inside the Distiller chassis and
on the outside of the boiler before each distillation cycle.
USING THE COUNTERTOP DISTILLER
WARNING:
Never remove the boiler while the fan motor is running, or
for 30 minutes after it stops. Severe burns can result from boiling water or
steam.
DO NOT
change position or location of distiller while it is operating
or cooling.
Operational
maintenance
and replacement
requirements are
essential for this
product to
perform as
advertised.
1. Set Distiller on dry, level, well-supported, stable surface.
2. Remove collector/dispenser bottle.
3. Remove boiler by grasping its handle and pulling it out of chassis.
4. Remove boiler cap by turning it counterclockwise (fig. D).
5. Loosen steam baffle securing nut by turning counterclockwise and
remove steam baffle (fig. D).
6. Rinse boiler thoroughly before filling. The water should be drained
through boiler spout.
7. Fill boiler with ordinary tap water to bottom of four tabs in boiler
opening, approximately 1 gallon (3.8 Liters). These tabs indicate the
MAXIMUM FILL POINT.
DO NOT OVERFILL
(fig. D).
8. Replace boiler cap by turning it clockwise until tight.
9. Make sure gasket is installed on long end of steam baffle and that it
is snug against flange (fig D). Insert long end of baffle, flat side down,
into the boiler spout. Turn securing nut clockwise onto spout until
tight, being careful to not cross thread.
IMPORTANT:
Wipe off all water deposits inside the Distiller chassis and
on the outside of the boiler before each distillation cycle.
6
Waterwise 9000 Distiller Use & Care Guide
Boiler
Collector/Dispenser
Bottle
Distiller Chassis
Figure
C