5
READ AND FOLLOW SAFETY INSTRUCTIONS
This is the Safety Alert Symbol. When you see this
symbol on your filter or in this manual, look for one
of the following signal words and be alert to the potential for
personal injury!
warns about the hazard that will cause death,
serious injury or major property damage if ignored.
warns about hazards that can cause death,
serious injury or major property damage if ignored.
warns about hazards that can or will cause death,
serious injury or major property damage if ignored.
NOTICE:
indicates special instructions not related to hazards.
Carefully read and follow all safety instructions in this manual
and on equipment.
Keep safety labels in good condition; replace if
missing or damaged.
Hazardous Pressure. Incorrectly installed
or tested equipment may explode, causing severe injury or
property damage.
Read and follow instructions in Owner’s Manual
when installing and operating equipment. Have a trained pool
professional perform all pressure tests.
Do not connect filter to compressed air under any
circumstances.
Do not connect system to a city water system or other external
source of pressurized water.
Do not connect filter to pumps capable of exceeding 50 PSI
(345 kPa) maximum pressure.
Open air release valve to vent all air from system before
operating the system.
Risk of falls and injury. Filter surface is slippery.
Do not allow children to stand or play on filter.
GENERAL INFORMATION
WHEN TO CLEAN THE FILTER:
The filter cartridge should normally be cleaned when the pressure
gauge reading increases 10 PSI over the start-up pressure.
In some pools, accessories such as fountains or pool cleaners may be
noticeably affected by the normal decrease in flow as the filter becomes
dirty. If so, clean the filter more frequently (that is, at a pressure
increase of less than 10 PSI) in order to maintain the required flow.
Clean a new pool as well as possible before filling pool and operating filter.
A typical pool installation will require approximately one week to obtain
and maintain the sparkle that your filter is capable of giving you.
Maximum pressure is 50 PSI (345 kPa). DO NOT connect the filter to a
city water system or to an individual water well system.
The Waterway Cartridge Filter is designed to filter water for swimming
pools and hot tubs only. On a new installation, we recommend:
1. Disassemble the filter after the initial cleanup. Follow
“Filter Disassembly/Assembly Procedure” on page 7.
2. Remove and hose down the cartridge to remove contaminant.
Maintain pool water pH between 7.2 and 7.6.
Make sure that the filter ring is securely locked in place before operating
filter.
Maintain the pressure gauge in good working order.
Replace a damaged gauge immediately.
Cleaning interval is based on pressure rise, not on the length of time the
filter is operated. Different water conditions will have different normal
cleaning intervals
NOTICE:
Some pool disinfectants may clog the filter cartridge. To maximize
cartridge life and filter cycle time, closely follow the disinfectant
manufacturer’s instructions when cleaning pool or filter. Failure to follow
these instructions may affect warranty coverage of the cartridge.
OPERATING INSTRUCTIONS
WARRANTY
For product registration visit: www.waterwayplastics.com.
For Warranty questions or claims please contact point of purchase.
