1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
TVSP THERAPY CYCLES
9
FILTER CYCLE PROGRAMMING:
At the start of Filter Cycles 1-4 the VS JET 1 will run on 40% speed, JET 2 (2-speed pump) will run on low for 15
seconds to prevent the spa water from becoming stagnant in the plumbing and air lines and to improve skimming action (removing debris and
suspensions from the water surface). Your spa is programmed from the factory with these defaults: Filter Cycle 1 is automatically activated at 8 a.m.
and operates JET 1 for 4 hours. Filter Cycle 2 is automatically activated at 8 p.m. and operates Jet 1 for 4 hours. Filter Cycle 1, or Filter Cycle 2 icons
will turn on when that filter cycle is running. The default setting is every day of the week. If the duration for Filter Cycles 3 or 4 are set to 0 hours these
cycles will skipped. See details of FILTER CYCLES setting in “Setting Screen” section.
OZONE SYSTEM:
Your spa is equipped with an ozone purification system. You will find that your spa water stays fresh and clear with significantly less
chemical usage. You will be able to go longer between complete spa draining. The ozone generator operates in conjunction with the JET 1 Filtration
Cycle. Ozone is on when JET 1 is in filtration mode. Ozone will turn off for one hour if user taps any icon on the top side panel (spa in use).
SPA CONTROL POWER LIMITATIONS:
The spa is protected by a 60A GFCI (maximum spa load should not exceed 48 Amps). The spa control deactivates
the heater if maximum load exceeds 48A. The spa control allows only three high speed pumps (14A per pump) to run at the same time. The spa control
will not heat when more than two pumps are running on high speed.
SPECIAL OPERATING INSTRUCTIONS:
For spas equipped with waterfall features.
Turn on waterfall features by pressing the “Jet 2” icon (2-speed
pump) on top side panel turn “on/off” water feature valve located on the lip of the spa and adjust water flow as desired. Please adjust the water flow
when the pump is running on high speed to prevent water splashing.
SPA FUNCTION ICONS
(continued)
