INSTALLATION INSTRUCTIONS
6. Attach the drain cover (#2) to the drain cover support plate (#8) using
the tool and the three #10 x 7/8 security screws provided. Waterway
requires the use of security screws to secure the cover. Apply 20 In-Lbs
torque to security Torx Cover Screws.
CAUTION: Use only supplied screws to secure the cover. DO NOT
use power tools.
7. If the Ultra Retro is on a curved wall such as a spa, or the wall/floor
of the pool is uneven, then the gap between the back plate of the Ultra
Retro and the pool finish must be filled. An underwater epoxy such as AB
epoxy putty may be used or if the pool is empty then silicon glue may be
used. Allow for the drying time in both cases before suction is applied to
the drain cover.
CAUTION: the SOFA back plate CANNOT be attached
to the wall using the adhesive(s).
NOTE:
For fastener repair, evaluation and replacement - if any of the listed fastener or fastener receptacles in these instructions are damaged in any
manner such that that the required torque specification cannot be achieved, both the fastener and receptacle parts must be replaced
Spacer
Figure 7
810-0256-2017.0521
©2021 Waterway Plastics
