Waterstone faucets are designed for 3 different faucet positions. Handle
on left, front and right. Your faucet is configured for the most common
installation (see below). To reverse this and have the handle positioned on
the left, connect the hose for cold water to the hot supply and the hose for
hot water to the cold supply. This will maintain the relationship of pulling
the handle for hot water or pushing for cold water.
HANDLE ON LEFT
HANDLE IN FRONT
HANDLE ON RIGHT
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
H
C
A
B
C D
A
B
E
E
G
C D
F
F
1.
Before connecting supply hoses,
flush supply stops to clear any
debris. Place a bucket underneath
stops and run water for 5 to 10
seconds. Turn water off.
2.
Carefully position hot and cold
supplies so they will not interfere
with other hoses.
3.
Connect supply hoses (A) to
supply stops (B). DO NOT use teflon
tape or plumbers putty. Turn water
back on and check for leaks.
CONNECTING SUPPLY HOSES
HANDLE POSITION
A
B
E
D
B
F
C
A
COUNTER
OR SINK
1.
2.
3.
4.
Slide washer (D) and thread the
clamp nut (E) onto threaded
shroud. Tighten nut snug to
underside of sink or counter.
Turn faucet to the desired
handle position. Securely
tighten clamp screws (F).
GANTRY
®
PULLDOWN FAUCET INSTALLATION
Using scissors, cut plastic tie
on hose protector tube (A) and
remove.
Fit flexible hoses (B, C) through
hole on counter or sink.
(No
plumbers putty is required.
O-ring will seal base)
.
RED FOR HOT
BLUE FOR COLD
OPTIONAL HOT COLD INDICATOR RING
(CONTEMPORARY ONLY)
1.
To reverse, or remove Hot and Cold Indicator
Ring, unscrew the metal cap, remove ring and flip.
2.
Slide ring back onto handle and screw metal
cap back on.
A
C
D
E
F
B
OPTIONAL DECORATIVE BUTTONS
To change button, find the slot (A) at bottom of
retainer ring (B). With a small standard screwdriver,
gently pry retainer ring from faucet handle (C).
Remove button assembly (D). Insert new button
by lining up pin (E) on
handle with hole (F)
on bottom of button
assembly. With slot
facing down, press the
button retainer ring
firmly back into place.
