figure 24 - Access to sinlge phase outdoor unit’s
terminal block
figure 25 - Connections to sinlge phase outdoor unit’s
terminal block
2 10 5 Electrical connections
on the single phase outdoor unit side
Access to the connection terminals:
-Remove the front panel. Remove the screws and the
front panel.
figure 26 - Finalisation of connection
to sinlge phase outdoor unit
Remove the screws
and push downwards
Service panel
Valve cover
Hook (4places)
Terminal
block
-Make the connections in accordance with the diagram
figure 33, page 30
.
-Use cable clamps to prevent the conductors from
being disconnected accidentally.
-Use the cover plate to hold the cables against the
insulating plate.
Terminal block
Interconnection between
the outdoor unit and
the hydraulic unit
General
electrical
supply
CAUTION
Fix cables so that cables do not make contact with the pipes
(especially on high pressure side).
Do not make power supply cable and connection cable come in
contact with valve (Gas).
Power supply cable
and connection cable
Valve (Gas)
Cable clip
Cable clip
Cover plate
Installation and operating manual "1533 - EN"
Air to Water Heat Pump
- 26 -
