Chapter 1
Installation Instructions
Step 4
– Programming the Boost Box
imPortAnt note: Please read steps 1-7 below before
beginning the programming sequence, as they must be
performed in the correct order and without delay. the
sequence may be re-started at any time by turning the
Boost Box off and disconnecting.
To program the Boost Box:
1. Turn the Boost Box on and wait for the LED to stop
flashing and remain steadily illuminated. Then rotate
the selector knob to the off position.
2. Turn your stereo on and note the volume level.
3. Rotate the Boost Box Control Unit selector knob all
the way clockwise until it stops at the Max Boost
position. The LED will flash rapidly several times and
will then begin to blink slowly. The Boost Box is now
transmitting commands. Note, this step may take
several minutes.
4. When the volume on your stereo increases by 4 steps,
immediately rotate the selector knob to the mid-point
position. This will lock-in the proper codes to control
your stereo. The LED will flash rapidly several times
and then the LED will turn off and stay off.
5. Rotate the selector knob all the way counter-clockwise
to the off position.
6. Rotate selector knob to mid-point and wait for LED to
stop flashing and remain illuminated.
7. Your Boost Box is now programmed and ready to use.
The Boost Box internal memory will store the correct
codes and will remain properly programmed even if power
is disconnected. The Boost Box will remain programmed
until it is successfully reprogrammed. If you install a
different stereo, your Boost Box may be reprogrammed at
any time simply by following the steps above.
7
Summary of Contents for boost box WSI 1103
Page 15: ...enjoy the ride...
