Watersnake GPSmart, Owner'S Manual

Page: 20 / 28

Watersnake
20
REPLACING A FOB BATTERY
1. Using a #1 phillips screwdriver, remove the two screws on the back of the fob.
2. Separate the fob sections
3. Remove the rubber membrane and the circuit board from the back half of the
fob shell.
4. Slide the battery out of its holder on the back of the circuit board and replace
with a new CR2032 battery. Be sure to position the battery with the Positive side
away from the board.
5. Reinstall the circuit board in the back half of the fob shell, taking care to make
sure it is properly positioned in the shell.
6. Place the rubber membrane over the lip on the back half of the fob shell and
press into place.
7. Place the front half of the fob shell over the rubber membrane and press into
place. Verify that all buttons are properly positioned within their opening and
function correctly.
8. Reinstall the two screws into the fob shell, taking care not to over-tighten the
screws.
The batteries in the wireless FOB should be capable of lasting a full
fishing season or longer under normal usage conditions. If your
system is powered up yet fails to respond to a FOB, or if you noticed
decreased wireless range, try replacing the battery.”
Use care not to press the small switch on the back of the circuit board near
the battery holder. If this switch is accidentally pressed, or the unit does
not respond to fob commands after replacing a battery, please contact your
nearest Watersnake dealer for further assistance.