12
Robot User Manual
[ ROBOT USER GUIDE ]
From status…
Action on the push-button
Action triggered by the push-button
An experiment is Running
The machine is put in Pause
An experiment is Paused
The machine is put in Resume
The installation mode (hotspot) is OFF
The installation mode is turned ON
1. The installation mode (hotspot) is ON
2. The machine status is not In Error
The installation mode is turned OFF
Any experiment status
1. The PC is shut down softly; The plus
2. The machine is put in Standby status
Any experiment status
The machine is put in Standby status
The machine is in Idle state
The machine is put in Standby status.
The embedded PC is turned OFF, so the
unit is no longer accessible via OneLab
The machine is in Standby status
The machine is turned ON and it is put in
Booting status
5 times
5 times
press for 20 sec.
press for 5 sec.
press for 30 sec.
(Emergency exit)
G. HOW TO USE THE ROBOT
Robot executes experiments described in protocols designed with OneLab software. The same software is required
to monitor the execution of such experiments. The communication between OneLab and embedded intelligence present in the
Robot is achieved via ethernet or Wi-fi connection.
It is also possible to partially control the Robot using the push button present on the face of the robot. In particular,
according to the duration of pressure applied to the button, the status of the Robot can be changed. The table below
summarizes the various possibilities:
LEDs can be blinking
after 15 seconds
Standby/Booting