2
ProSwitch 1007 – Unmanaged User’s Manual
Page 4
2.0
Package Contents - ProSwitch
-Secure-1007 - Unmanaged
Examine the shipping container for obvious damage prior to installing this product. Notify the carrier of any damage
that you believe occurred during shipment. Ensure that the items listed below are included.
The ProSwitch -Secure-1007 package contains the following:
8 port switch
AC power cord
2.1 Product
Description
A switch can be used to overcome the hub-to-hub connectivity limitations as well as improve overall network
performance. Switches make intelligent decisions about where to send network traffic based on the destination
address of the packet. As a result, the switch can significantly reduce unnecessary traffic. The ProSwitch-Secure
1007 - unmanaged models provide 10/100Base-TX ports with an optional 100Base-FX port in a cost effective pocket
size package. The 10/100Base-TX ports auto negotiate speed and half/full duplex modes.
2.3
Location of the ProSwitch -Secure-1007
The ProSwitch 1007 can be installed quickly and easily. However, for an installation with minimum impact on the
existing network, please read the following information carefully. Installing the ProSwitch 1007 unmanaged switch
involves three steps:
1. Choosing a location
2. Supplying power
3. Connecting the switch
Consider the following criteria when selecting a location for the switch:
Avoid dusty locations
Avoid electromagnetic noisy areas, such as locations close to power transformers or radio transmitters
Avoid temperatures below 32° to 104°F (0° to 40°C)
Allow sufficient space for proper ventilation
Allow a clear view of the front panel LED indicators
Allow easy access to the front panel ports and the rear panel switches
The power outlet should be within six feet (1.8m) of the switch
3.0
Connecting the ProSwitch -Secure 1007 to Your Network
The1007 has been designed to support all standard Ethernet media types within a single switch unit. The various
media types supported along with the corresponding IEEE 802.3 and 802.3u standards and connector types are as
follows:
