2
ProSwitch Lite User’s Manual
Page 5
Fiber:
Speed
Media Type
Max. Distance
Connector Type
Port Speed
Half/Full
Duplex
100Base-FX Multimode fiber
2km
SC, ST or MTRJ
100/200Mbps
100Base-FX
Singlemode fiber
15, 40 or 75KM
SC 100/200Mbps
Copper:
10Base-T
CAT3, 4 or 5
100m (328ft)
RJ45
10/20Mbps
100Base-TX
CAT5 or 5E
100m (328ft)
RJ45
100/200Mbps
NOTE: Since all switch ports are auto-sensing for both 10 and 100Mbps, it is recommended that high quality CAT5
cables or above (which work for both 10Mbps and 100Mbps) be used whenever possible in order to provide flexibility
in a mixed-speed network. Because the switch supports auto MDI/MDI-X detection, normal straight through cables
for both workstation connection and hub or switch connection can be used. All ports are auto MDI/MDI-X, so you can
use any of the ports to connect a port on another hub or switch with straight through or crossover cables.
4.0
Mounting the ProSwitch Lite
Table-Top or Shelf Mounting
The ProSwitch Lite can be easily mounted on a table-top or any suitable horizontal surface. There are four rubber
feet provided for stability so finished surfaces won’t be scratched.
5.0
Powering the ProSwitch Lite
The Lite switch is equipped with a universal power adapter that accepts AC input voltages from 100 to 240VAC and
50 to 60 Hz.
To supply power to your switch:
1. Plug the connector of the power cord into the power port on the rear panel of your switch.
2. Plug the power adapter into an AC wall outlet.
3. Verify that the Power LED is lit. If it is not, check the following:
The power cord is properly connected to the wall outlet and to the power connection on the switch.
The wall outlet is functional.
Note: Network cable segments can be connected or disconnected from the switch while the power is on, without
interrupting the operation of the switch.
