Page | 5
Ascento Group Australia 37 Export St, Lytton, Brisbane, QLD 4178 P: 1800807604
WARNING!!!
ELECTRICAL PRECAUTIONS
Before servicing a pump, always shut off the power supply and then make sure you are not standing in water and that there is no risk of
electrical shock. If pump is direct-wired to the electrical circuit, have a qualified licensed electrician disconnect it before attempting any
repairs or servicing.
DO NOT ATTEMPT ELECTRICAL REPAIRS OF ANY SORT UNLESS YOU
ARE A LICENSED ELECTRICIAN
WARRANTY RECORD - FILL IN AND RETAIN THIS WITH YOUR ORIGINAL PURCHASE RECEIPT
PURCHASER NAME......................................................................................PHONE NO..................................................
DATE OF PURCHASE ………../.........../............DEALER/STORE NAME..............…................................…...........................
DEALER SUBURB/TOWN….....…...............….......................................PHONE NO…..........................................................
BRAND & MODEL NUMBER OF PUMP…….........................................SERIAL/BATCH NUMBER…………………………………..
Serial number is usually on the label on the electric motor cover. Do NOT send this form to us, retain it for your record.
INSTALLATION CHECKLIST: MUST BE FILLED IN FOR WARRANTY TO APPLY
Installer Name ______________________________ Qualification:_______________(write Owner if applicable)
Phone Number:_________________ If installed by a Plumber or Electrician, Licence No: _____________________
Installation Address: ____________________________________________________________________________
Tick the boxes as the item is completed/correct, put n/a if not applicable;
[ ] The Pump is being used for an appropriate purpose for which it is intended, according to the instructions
[ ] The Power Circuit the Pump is connected to is RCD (Safety Switch) Protected
[ ] A Y-Strainer or Pre-filter is installed in the suction pipe to prevent particles entering the pump
[ ] All swarf has been removed from the tank after cutting openings etc.
[ ] Barrel Unions are fitted on the pipe connections for easy removal & replacement
[ ] A Ball Valve or Gate Valve is fitted to the suction pipe (the pipe from tank to pump)
[ ] Pipe is sized appropriately for the application (diameter and length)
[ ] The installation is constructed so the pump can be easily removed or replaced.
[ ] If applicable: The pump is installed in accordance with National & Local Plumbing Regulations
[ ] The Electrical Supply cable is plugged into a Power Outlet that is in accordance with the current standard of Electrical Safety
Regulations AS/NZS 3000 – or it is wired directly to the power circuit by a Licenced Electrician.
[ ] The Pump has been started, tested, and operates correctly.
[ ] The pipework and all connections including the barrel-union on the pump, have been checked for leaks.
[ ] The Owner has been shown how to re-prime and re-set the pump (re-fill the pump wet-end with water if it runs dry)
Signed by the Installer: _____________________________ Date Installed:_____/_____/________
