6
High
Low
Of
Power
OFF
Fill
Eject
Insert
Filling the Reservoir
Lif the fip top on reservoir and fll the reservoir with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle. The colored ring will be fush with the end of
the knob if the tip is correctly locked into place. To remove the tip from the handle, press the tip eject button and pull tip
from handle.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by simply sliding the pressure/power switch on the handle.
Slide power switch up 1 click for low (l) pressure and 2 clicks for high (ll) pressure.
Recommended Technique
Lean low over sink and place the tip in mouth. Aim the tip toward teeth, and turn the unit ON (l).
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefy
between teeth. Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline.
Slightly close lips to avoid splashing
but allow water to
fow freely from mouth into the sink. Keep unit upright during use for best results.
When Finished
Turn the unit of. Empty any liquid lef in the reservoir. If desired, the reservoir may be removed from the power handle
by sliding the reservoir down towards the base of the unit. To replace the reservoir on the power handle, simply slide it up
towards the top of the unit.
