INSTRS110110 rev 6 01/03/15
Page 3
4.2 RainsaverMK4E installation.
The RainsaverMK4E must be mounted in the horizontal position, and the RainsaverMK4E
power socket to accept the pump power lead must hang in the down position.
The
RainsaverMK4E
can be
Wall mounted
or
Pump Mounted
i.e. mounted directly onto a pressure
pump outlet. The steel wall mounting bracket, which is connected to your
RainsaverMK4E,
can be
rotated to allow the unit to be wall mounted in either direction, or may be removed for pump
mounting.
4.21 Wall Mounting:
The
RainsaverMK4E
can be mounted outdoors on a flat vertical surface.
The
RainsaverMK4E
can be mounted with the mains inlet pointing in either direction.
Pressure tank pre-charge pressure should be 65% of pump maximum pressure.
Wall Mounting Instructions:
-
To reverse the mounting direction
, so that “Mains”
inlet will be on the left side and
“House” outlet on the right, follow the first steps of Pump Mounting Instructions below to
remove and reverse the mounting bracket. Then continue:-
-
Remove the
RainsaverMK4E
lid by unscrewing the 4 Phillips head screws
-
Hold the
RainsaverMK4E
in the desired position and mark the screw centres through the
keyhole slots in the mounting bracket. Return the
RainsaverMK4E
to the box.
-
Drill and insert mounting hardware into the mounting surface (wall). Insert screws leaving
a few millimetres under the head to allow insertion of the mounting bracket
-
Mount the
RainsaverMK4E
onto the screws through the keyhole slots in the mounting
bracket. Tighten screws to secure the bracket to the wall
-
Replace the
RainsaverMK4E
lid and re-tighten the four (4) lid screws.
