background image

21

 

1 STATUTORY RIGHTS OF CONSUMERS

The  warranty  terms  set  out  below  do  not 
exclude any conditions or warranties which may 
be  mandatorily  implied  by  law,  and  your 
attention  is  drawn  to  the  provisions  of  the 
Australian  Trade  Practices  Act,  1974  and  the 
State  legislation  which  confers  certain  rights 
upon  consumers.  The  following  warranty 
supplements these.

2. WATERMAID® WARRANTY

(a)WATERMAID  PTY  LTD  warrants  to  the 
WATERMAID®  owner  that  the  WATERMAID® 
Power  Supply  (excluding  any  time  clock 
component)  shall  be  free  of  defects  in 
manufacturing  or  workmanship  for  a  period  of 
two (2) years from the date of purchase.

(b)WATERMAID  PTY  LTD  warrants  to  the 
WATERMAID®  owner  that  the  time  clock 
component  contained  in  the  WATERMAID® 
Power  Supply  shall  be  free  of  defects  for  a 
period  of  one  (1)  year  from  the  date  of 
purchase.

(c)WATERMAID  PTY  LTD  warrants  to  the 
WATERMAID®  owner  that  the  WATERMAID® 
Cell shall be free of defects in manufacturing or 
workmanship  for  a  period  of  twelve  (12) 
months  from  the  date  of  purchase.    An 
additional  forty  eight  (48)  month  pro-rata 
replacement 

warranty 

applies 

to 

the 

WATERMAID® Cell.

Any parts in the WATERMAID® Power Supply or 
Cell  found  by  WATERMAID  PTY  LTD  to  be 
operationally  defective  will  be  repaired  or 
replaced  at  WATERMAID  PTY  LTD's  sole 
discretion.

d)  The  WARRANTY  as  outlined  in  paragraphs 
2(a), 2(b) and 2(c) above DOES NOT apply:-

(i)  To  any  defect  or  failure  caused  by  misuse, 
abuse,  abrasion,  buildup  on  Cell  electrodes, 
electrical  faults,  power  surges  (including 
lightning  strikes),  insects,  harsh  chemicals, 
incorrect  water  balance,  wear  and  tear, 
accident,  non-observance  of  installation, 
operating  and/or  cleaning  instructions  or  any 
other  condition  outside  of  the  control  of 
WATERMAID PTY LTD;

(ii)  If  the  product  has  been  serviced  by  a 
person not authorised to do so by WATERMAID  
PTY LTD or with non approved parts;

(iii)  If  any  serial  number  or  compliance  label 
has been removed or defaced;

(iv)  If  the  product  has  not  been  fully  paid  for 
by  all  parties  to  the  sale  or  is  repossessed 
under any financing agreements.

(v)  Where  the  WATERMAID®  Power  Supply  or 
Cell  has  been  subject  to  any  use  other  than 
normal  domestic  pool  use.  The  warranty 
applicable to commercial applications is limited 
to 12 months from the date of purchase.

3. FREIGHT 

Subject to the WATERMAID® owner's statutory 
rights referred to in clause 1, WATERMAID PTY 
LTD  reserves  the  right  to  charge  for  any 
services  not  covered  by  this  warranty, 
including freight costs.

4. OTHER LIABILITY 

Subject to the WATERMAID® owner's statutory 
rights  referred  to  in  Clause  1  and  2, 
WATERMAID  PTY  LTD  hereby  excludes  to  the 
maximum  extent  permitted  by  law  all  other 
liability in respect of the product.

5. CLAIMS UNDER WARRANTY

If a defect covered by this warranty arises, the 
WATERMAID® 

owner 

should 

contact 

WATERMAID  PTY  LTD  as  soon  as  it  arises  and 
advise the nature of the defect.  If a repair or 
replacement  is  made  under  warranty,  the 
warranty  period  will  not  extend  past  the 
original expiration date of the warranty.

6. REPAIRS

For a WATERMAID® Power Supply repaired by 
WATERMAID PTY LTD after the warranty period 
has  expired;  a  three  (3)  month  defect  free 
warranty  applies  to  any  REPLACED  PART.  This 
warranty excludes any defect or failure caused 
by  any  condition  outside  the  control 
WATERMAID PTY LTD.

Effective 1 January 2011. Replaces all undated warranties and warranties dated before 1 January 2011.

®

Copyright © Watermaid Pty Ltd

This  Owner's  Handbook  contains  information  relating  to  WATERMAID®  salt  water  chlorinators  (as 

pictured  above)  as  well  as  general  information  on  pool  maintenance.   

Please  read  the  SAFETY 

INSTRUCTIONS on page 20 before first use.

WM40 Power Supply

(Time clock optional)

The WM40 Power Supply can be coupled to any one of the Cells below:

EZY300 Cell

(40 or 50mm, 1½ or 2”)

Salt Level: 6000ppm

Patented Design

QT300 Cell

(40mm or 1½”)

Salt Level: 6000ppm

XT300 Cell

(50mm or 2”)

Salt Level: 6000ppm

XT400 Cell

(50mm or 2”)

Salt Level: 4000ppm

QT400 Cell

(40mm or 1½”)

Salt Level: 4000ppm

Copyright © Watermaid Pty Ltd

®

Summary of Contents for WM40













Reviews: