WaterLogic WL800 - MAX II, Operating, Installation And Service Manual

Page: 36 / 75

CAUTION! USE SANITIZER COMPATIBLE WITH STAINLESS STEEL AND ACETAL PLASTIC.
Do not allow the sanitizer solution to remain in the system for more then 10-15 minutes unless
otherwise directed by the sanitizer manufacturer.
Flushing the Sanitizer from the Machine
10. Place a pitcher, catch basin, or other container under the faucet of the WL800 .
11. Flush the Cold Tank. Run several gallons of water through the faucet by dispensing cold water to
dilute and remove the sanitizer from the cold circuit. You can use chlorine test strips to evaluate the
water.
Fill the Hot Tank
12. Press the Hot Cup Touch Lever to fill the hot tank. Water will dispense from the faucet once the hot
tank is full. Flush until water is clear.
WARNING! HOT CIRCUIT IS NOT SANITIZED. WATER MUST EXCEED 171
o
F
Water in the hot circuit is not sanitary until the temperature over 171
o
F for 5 minutes.
Do Not Ingest and avoid contact until heater is turned on for at least 5 minutes.
Compressor Test
13. Heater and compressor will turn on automatically once water level has reached the full level sensor.
14. Allow unit to run for 1 hour. Check hot and cold temperatures. Cold = 41°, Hot = 187°.
15. Once the machine reaches its target temperature, the compressor and fan will shut off. Draw a
glass of cold water and verify it is has been chilled to proper temperature.
WARNING! VERY HOT WATER CAN BURN OR SCALD.
Hot water should be dispensed carefully into insulated container to avoid injury.
Drain the WL800 for Transport
16. Drain the WL800 for transportation per the Draining Instructions in this manual.
WARNING! STORE UNIT EMPTY . ALWAYS SANITIZE BEFORE REUSE.
The unit must be completely drained and sealed before storing to avoid stagnation and reduce
microbiological contamination (potential bacterial growth).
WL800 Operating, Installation, and Service Manual Page 36 - Revision: 5-14-2015