5
2.7
Re-connect the UV lamp connector
making sure the connectors are lined
up correctly as they will only fit together
when correctly aligned
2.8
To remove the Filter, do the following:
1. Rotate the red rotating lever so that it is parallel
with the side panel
2. Insert your finger into the round hole of the
lever, and pull the lever up to the
vertical position
3. Pull the lever straight up to remove
the Filter assembly (Slight force may
be required. Support the unit with
your other hand while pulling the
filter out).
Note: Dispose of the filter
following your local guidelines
1.
2.
3.
2.9
Fit the new filter assembly into the
appliance as follows:
1. Insert the filter assembly back into
its cradle, aligning the two male spigots
with the female holes in the cradle
2. Push firmly until the filter sits snugly
and is flush inside the cradle and with
the cradle top surface
3. Lock the filter by closing the locking
lever until it ‘clicks’ into place
4. Rotate the red rotating lever back into
the LOCK position
1.
2.
3.
