WL3 FW
User Manual
Page 6 - Revision: EU 17-09-2020
WARNING!
TIP HAZARD.
Dispenser could tip or fall causing serious injury. Always install unit on a
firm, flat, and level surface and secure the
WL3 FW Water Treatment System
to the base cabinet with
the screw provided to lock the components together. Secure unit to cabinet, wall, or floor if needed.
Never place heavy items on top of unit and never climb, stand, or hang on unit or storage cabinet to
prevent injury and damage.
WARNING!
UNIT IS HEAVY. TWO PERSON LIFT REQUIRED.
Transport unit empty and always use
material handling equipment or two people with proper lifting technique to reduce injury risk.
WARNING!
STORE AND TRANSPORT UNIT EMPTY. ALWAYS SANITIZE BEFORE USE.
The unit must be completely drained and sealed before storing to avoid stagnation and reduce
microbiological contamination (potential bacterial growth). Sanitize before use to eliminate any
potential microbiological contaminates
CAUTION!
INDOOR USE ONLY.
Intended for household use only. Never expose to direct sunlight,
heat sources, or ambient air temperature above 32°C (90°F) or below 2°C (35°F). Install indoors and
keep unit away from humidity levels above 65%. Never expose to freezing temperatures. Ensure there is
adequate clearance around the unit to allow refrigeration system condenser to dissipate heat. Warmer
environments require more clearance around the unit. Minimum clearance around all surfaces of the
machine is 50mm. Installs where the ambient temperature exceeds 25°C, require a minimum of 100mm
clearance for proper heat dissipation and efficient operation.
CAUTION!
USE A WATER PRESSURE REGULATOR.
Waterlogic will not be responsible for injury or
damage caused by excessive water pressure. Input or feed pressure must be 2.5 bar (36 psi) to 3.5 bar
(51 psi). Be aware of any potential pressure surges caused by building/municipal pumping stations.
Water block devices and external leak detectors are strongly recommended. Locate the unit as close to
the water supply and the electrical connections as possible to minimize risk.
CAUTION!
USE PROPER SUPPLY LINES AND FEED WITH POTABLE AMBIENT WATER ONLY.
Feed water over 32°C (90°F) may damage the treatment components. Always use supply lines with
adequate pressure rating and UV resistance. Close water supply valve and contact service
representative if a leak is noticed.
Contact Waterlogic for assistance or help finding an Authorized Service Representative.
