12
Sanitization Steps
STEP 1:
TURN OFF WATER SUPPLY - CLOSE INLET
SUPPLY NEEDLE VALVE ALL THE WAY
STEP 2:
DEPRESSURIZE SYSTEM - OPEN FAUCET
SUPPLY UNTIL ALL WATER IS EMPTIED
Use a clean drip pan or basin to continue to catch any spilled
water remaining in the housings as you remove the
membrane and cartridges.
STEP 3:
DISCONNECT THE FEED TUBE FROM THE
MEMBRANE HOUSING MODULE. UNSCREW THE
MEMBRANE HOUSING MODULE END CAP AND REMOVE
THE MEMBRANE ELEMENT. PUT THE MEMBRANE
ELEMENT ASIDE ON A CLEAN DISINFECTED SURFACE.
(Unless the membrane element is being replaced at this
time, then discard the old membrane.)
STEP 4:
OPEN THE FILTER SUMPS WITH THE SUMP
WRENCH SUPPLIED AND REMOVE THE CARTRIDGES.
STEP 5:
CLEAN THE FILTER SUMPS WITH SOAP AND
CLEAN WATER. USE A CLOTH OR SOFT BRUSH AS
REQUIRED. CLEAN THE INSIDE OF THE MEMBRANE
HOUSING AS WELL.
(You may need to pay close attention to the O-Ring seals and
re-grease them afterwards with silicone lubricant)
STEP 6:
REINSTALL THE FILTER SUMPS (EXCEPT THE
1ST PRE-FILTER SUMP) AND THE MEMBRANE CAP AND
RECONNECT THE INLET TUBING TO THE MEMBRANE
HOUSING CAP.
STEP 7:
MIX UP A DISINFECTANT SOLUTION OF 1
TEASPOON OF 5.25% BLEACH IN 1 GALLON OF WATER.
Figure 12
Figure 13
Figure 14
Summary of Contents for E35TFC-2SF
Page 2: ......
Page 21: ...17 Reverse Osmosis Drinking Water System Flow Diagram all models...
Page 23: ...19...
