![background image](http://html2.mh-extra.com/html/waterboss/cityboss/cityboss_installation-and-service-manual_5169564017.webp)
14
Installation And Start-Up Procedures
8. Setting Number. For
waterBoss
®
,
BigBoss
®
, and
cityBoss
®
for municipally-supplied
water, determine your controller setting number. Do not guess at the setting; continued water
quality problems or damage to the unit could result.
Municipal water - call your local water company to determine your water hardness in
grains
per gallon. This will be your setting number. Or, follow the instructions on the
hardness
test strip provided with your
cityBoss
®
to determine your hardness
reading. This will be your setting number.
Well water - follow the instructions on the pH and hardness test strips provided with
your
waterBoss
®
to determine the pH and hardness of your water.
Iron adjustment : if pH is 7 or above and you know your water has iron, add 15 to
your hardness reading in grains per gallon and enter the result as your setting #.
Example: hardness in grains per gallon from test strip is 20 + 15 = 35 = setting #.
This is a temporary setting until you have an accurate water test.
If the result of your hardness test strip reaches the test maximum of 25 grains per
gallon, mix 1 cup tap water with 1 cup distilled water, then retest for hardness. Multiply your
reading x 2 and use this number as your setting number. If the test strip result is
still
25 grains per gallon, call your HelpLine. Or, contact the company below to test for hardness,
iron and pH.
WATERSCREEN
National Testing Laboratories, Inc.
1-800-458-3330 - 9 am - 5 pm EST
If you feel you have an abnormal amount of iron, push the powerClean
®
button for
mod-
els
waterBoss
®
and
BigBoss
®
only. Also, be sure to use salt with an iron-cleaning additive.
Be aware that
cityBoss
®
for municipally-supplied water is not designed to treat water with
iron. If pH is below 7, refer to acid neutralizing filters, page 41.
9. Adding Water & Salt. Be sure to remove any packaging or installation materials before
adding salt. Next, add not more than 2 gallons of water to the brine cabinet. Then add salt to
the brine cabinet, wait 2 hours then push the immediate recharge button and hold for 5 sec-
onds. A regeneration cycle will begin and continue as follows:
BigBoss
®
, 37 minutes;
cityBoss
®
for municipally-supplied water, 26 minutes; and
waterBoss
® ,
26 minutes. After the
first regeneration, your softener will automatically refill the correct amount of water in the brine
cabinet. See figure 10.
10. Refill Salt when the salt level drops below the water level in the brine cabinet. Always
keep salt above water level. See figure 10
CAUTION! Failure to install, operate and maintain your water treatment
appliance as instructed will VOID the product limited warranty.
NOTE! Make sure the Owner's Limited warranty Card is filled in and mailed
within 30 days of installation. NO POSTAGE REQUIRED.