background image

WATERAX 

OT-4NX Owner's Manual 

 

05/2015 

Important Safety Instructions 

It is recommended that all information provided in this manual be carefully read and 
understood before performing any operation of or maintenance to the equipment. 

The procedures listed in this manual are general operating and maintenance procedures. 
They should be taken in addition to any procedures, policies and guidelines established 
by the authority having jurisdiction. Where conflicts arise, all parties (authority having 
jurisdiction and 

WATERAX

 Inc.) will need to be contacted to determine the best 

resolution.  The solution will need to address the safety of the operator along with the 
proper performance and life expectancy of the unit. 

Personal Safety Advisory  

READ THIS MANUAL BEFORE OPERATING YOUR EQUIPMENT! 

The improper use of the 

WATERAX

 backpack pump could result in injuries as well as 

damage to the equipment. Any operator should familiarize himself with the equipment and 
its capabilities before trying to operate the equipment in an emergency situation. Please 
read this entire manual before using your 

WATERAX

 backpack pump and follow all 

Personal Safety Advisories.  

Warnings   

  Always wear eye protection when operating the backpack pump. 

  Do not operate if mentally or physically fatigued. 

  No modifications and/or alterations may be made to the equipment. Any such 

modifications not only void the warranty but can make the unit dangerous to anyone 
operating it. 

  Never use flammable liquids, caustics, acids or hot water in the tank. 

  Do not leave unit in the sun when not in use. 

  Always inspect hose and connections before each use. 

  Do not store or use chemicals in the tank. 

  Keep the unit out of the reach of children. 

 

Preventing Damage to Equipment  

The following recommendations will help avoid damage to your equipment: 

  Flush the hand pump and tank with fresh water if it has been used to pump salty, 

brackish, high mineral content water, water containing debris, or foam injected water. 
Check that debris is cleared before using hand pump again. 

  Always use the fill strainer when filling the tank.  

  Clean and rinse hand pump and tank with clean water after each use. 

  For storage, completely drain the hand pump, tank and hose of all water. 

  Store in a cool and dry area. 

 

 

Summary of Contents for OT-4NX













Reviews: