4
5
Image 1
3. Fill the filter bottle with 2lt of water and allow to filter into the water
dispenser.
4. Drain and discard the water from the water dispenser using the taps
and repeat point 3 twice more. (until water is clear in the bottom
compartment of the filter bottle.
5. Follow instructions 5 & 6 of water dispenser installation instructions.
Installation of Standard Water Bottle
1. Fill your standard water bottle with water and secure the bottle cap
onto the bottle neck.
2. Invert the bottle and pierce the bottle neck onto the spike in the
middle of the bottle support, ensure the standard bottle is sitting level
on the water dispenser. See Images 1 - 3 above
3. Follow instructions 5 & 6 of water dispenser installation instructions.
Image 2
Image 3
2. Insert the Filter Bottle, with the Bottle Valve attached into the open area
(Reservoir Tank) on top of
the water dispenser,
ensure that the Filter Bottle
sits level on the top of the
water dispenser.
See Images 4 - 5
Image 4
Image 5
Model No.:
D55
Rated voltage Frequency:
220 - 240V / 50Hz
Rated Heating Power:
500W
Rated Cooling Power:
100W
Hot Water Capacity:
5L/h
Cold water capacity:
2.0l/h
Refrigerant:
R134a
Optimum Environmental Ambient 10˚C - 38 ˚C
Temperature
Technical Data
Circuit Diagram
Heater
SW1
PTC
Yellow
Compressor
E
N
L
Red
Temp Control I
Thermostat
Temp Control II
SW2
Protector
