4
5
5. Installation of the Mini Water Dispenser
1. Remove the Water Dispenser from its packaging.
2. Place in an upright position away from direct heat or sunlight.
3. Clean the Water Dispenser by wiping down the exterior with soap and
clean water. (DO NOT get any soapy water inside the water reservoir)
4. Insert your Filter Bottle (see section 6). It is recommended that you
flush your Water Dispenser before use, and each time you replace
your Filter Cartridge. Fill the Lower Container with approximately 2lt of
water and allow to drain into the Water Dispenser, drain this water via
both water taps and the quick drain valve situated on the underside of
the Water Dispenser. Repeat another two times.
5. Insert the Upper Container into the Filter Bottle and insert the soaked
Filter Cartridge, pour 2lt of water into the Upper Container and discard
from both the cold and ambient water taps to eliminate any carbon
dust that may come out of your Filter Cartridge.
6. Once water has filled the reservoir tanks and is flowing out of both
the ambient and cold water taps in the Water Dispenser, allow to
stand for a few minutes then plug the water dispenser into a wall
socket. Turn on the power switch on the back of the water dispenser.
The cooling indicator and the power lights on the front of the water
dispenser will come on.
7. Allow the Water Dispenser to stand for a while to reach the optimum
water temperature.
6. Installation of the Filter Bottle
1. Remove the Filter Bottle from its packaging and wash in warm soapy
water, rinse thoroughly.
2. Remove the Filter Cartridge from its plastic wrapping and submerge in
a bowl of water, allow to soak for at least 30 minutes
3. Assemble the Single Check Valve on the underside of the Lower
Container. Remove the nut from the top of the Single Check Valve,
insert the silicon tip into the hole on the bottom of the Lower Container
Lower
Container
Nut
Single
Check
Valve
Image 1
and secure the Single Check Valve
with the nut. (see Image 1)
4. Once the Single Check Valve is
assembled correctly onto the Lower
Container, insert the Single Check
Valve and Lower Container into
the recess on the top of the Water
Dispenser.
5. Insert the Upper Container inside the
Lower Container.
6. Remove the Filter Cartridge from the bowl of water.
7. Insert the Filter Cartridge into the recess in the Upper Container.
Press down firmly to ensure a seal on the O-ring.
8. Fill the upper container with 2lt of water and allow to filter through,
follow steps 5 - 7 in Section 5 if this user manual.
7. Cleaning and Maintenance
1. The Water Dispenser should be cleaned at least once a month and
everytime you change your Filter Cartridge.
2. Drain all water from you Water Dispenser. Move the Water Dispenser
over a bucket or sink and remove the quick drain cap situated on the
the underside of the unit. Press the butterfly clip together and remove
from around the Quick Drain Silicone Cap, pull the cap off and allow
the unit to drain completely. Also press down on the taps to ensure all
water is removed from the Water Dispenser.
3. Once the Water Dispenser is drained, remove the bottle from the
Water Dispenser. Remove the Filter Cartridge from the Filter Bottle
(if the Filter Cartridge is to be changed follow instructions in Section
6 steps 1 - 2, and discard your old Filter Cartridge) and place in a
bowl of water to keep moist.
4. Clean all the components with a mild detergent and water and
rinse thoroughly.
5. Re-assemble as per section 5
