WaterSource
®
Cellular Functional Water
®
26
27
How to reset the filters
how to change the filters
①
ow to Change the Filters
H
②
③
④
⑤
Shut off the water supply to the unit.
Turn the power off and unplug the
power cord. Open the front door of the
product.
Raise the filter to be replaced and turn it
counter clockwise to remove it.
Put the new filter into the right position
by turning it clockwise.
When installing the filter, the connec-
tion bump of the head and the connec-
tion groove on the top of the filter
should be completely combined.
Close the door, plug the power cord
back in, reengage the water supply and
switch the unit back on.
Close
Open
After initializing the filter, press the H
2
O button and run purified water for 3minutes.
You are highly recommended to follow this process to use the machine properly.
ow to Reset the Filters
H
①
②
③
④
⑤
Replace the target filter.
After replacing the filter, press the F1 icon for 3 seconds.
Selected filter is initialized and beeps twice.
Voice announcement : "1st Filter / initializing was performed."
Next, press the F2 icon for 3 seconds.
Selected filter is initialized and beeps twice.
Voice announcement : "2nd Filter / initializing was performed."
Filter usage is displayed in 0 percent(0%) when the filter is
initialized properly.
The water outflow selection mode is available for operation.
Unless the quantity filtered is reset, the corresponding filter replacement
message keeps responding.
