Water Right ASP1-1044 Installation Instructions & Owner'S Manual Download

Page: 10 / 28

OPERATING DISPLAYS AND MAINTENANCE

1 . GENERAL OPERATION:

When the system is operating, one of five displays may be shown and will alternate with the installing dealer’s name

and phone number for future service. Pressing

NEXT

will alternate between the displays.

Time of Day Screen:

Displays the current time of day, the day of the week, and flow rate.

2. Flow Rate Screen:

Displays the current treated water flow rate through the system in Gallons Per Minute.

3. Capacity Remaining Screen:

Displays the amount of gallons of treated water remaining until the system triggers a regeneration.

4. Days to a Regen Screen:

Displays the number of days until the system triggers a regeneration. Based on the days override value.

5. Dealer Name Screen:

Displays dealer specific name and phone number. This scrolling display will only appear if set by the dealer.

If the system has called for a regeneration that will occur at the preset time of regeneration, the words “REGEN TODAY” will appear on the display.
If a water meter is installed, “GPM” flashes on the display when water is being treated, indicating gallons per minute flowing through the system.

2 . REGENERATION MODE:

Typically, a system is set to regenerate at a time of no water usage.

If there is a demand for water when the system is regenerating, untreated water will be delivered.

When the system begins to regenerate, the display will include information about the step of the

regeneration process and the time remaining for that step to be completed. The system runs through

the steps automatically and will reset itself to provide treated water when the regeneration has been

completed.

3 . MANUAL REGENERATION:

Sometimes there may be a need to regenerate a unit before the control

valve calls for it. This may be needed if a period of heavy water use is anticipated or when the system has been

operating without salt.

• To initiate a manual regeneration at the next preset regeneration time, press and release the

REGEN

button. The words “REGEN TODAY” will flash on the display to indicate that the system will regenerate

at the scheduled regeneration time (see the Programming Procedures section). If you pressed the

REGEN

button in error, pressing and releasing the button again will cancel the command.

• To initiate a manual regeneration immediately, press and hold the

REGEN

button for three seconds. The system will begin to regenerate

immediately.

This command cannot be canceled.

Once a manual regeneration is initiated, the unit will enter the FILL position. This position allows water to enter the brine tank until it reaches the

proper level. Once this position is complete, you will notice a 240 minute (4 hours) SOFTENING position. This 4 hour window allows the salt to

dissolve and achieve proper brine strength. During these FILL and SOFTENING positions, you will have softened water available for use. Once the

unit advances to the BACKWASH position and subsequent positions thereafter (see Start Up Instructions for regeneration sequence), the unit will

deliver water, but it will be untreated.

IMPORTANT: With the Dry Salt Storage Feature, the brine tank will refill 4 hours before the actual regeneration occurs. You may

experience a small amount of noise for a short period of time at 10:00 p.m. (with factory settings) on the night that the

regeneration is to occur. This noise is only the brine tank filling and at no time during this process will you be without

treated water.

FLOW RATE

GPM

8.0

CAPACITY REMAINING