8
Drain Connection:
Drainpipe should be 1/2"
Hose or larger and
terminated in a manner that
is acceptable to local
codes.
Outlet Connection:
Standard fittings are 3/4"
Male Copper Tubing
Inlet Connection:
Standard fittings are 3/4"
Male Copper Tubing
Safety Overflow:
If the brine tank is located in an
area that could be damaged by a
salt water overflow this fitting
should be connected without
reduction to a gravity flow drain
capable of 1 U.S.G.P.M. minimum
continuous flow.
Brine Valve Setting:
( This is a factory setting. Only
adjust when required. )
Measure from the top of the
crown nut (1) to the bottom of the
bell float (2). Consult factory for
settings.
(1). Crown Nut
(2). Bottom of Bell
Typical Drain Fitting (not included)
Gasket and Fitting position
To Softener
To Plumbing
Brine Connection:
Plastic hose from the brine
tank connects here. Insert
hose into connector to the
depth of the nut and hand
tighten. Tug-test to 15
pounds.
By-Pass Valve Not
Included
Summary of Contents for 2401 Series
Page 1: ......
