5
DOWN BUTTON
to change the maximum number of days
between regenerations. Setting to off disables
this feature.
Pressing the:
SCROLL BUTTON
again moves you the next setting
The next series of steps are critical to
the valve operation. Only experienced
operators familiar with this units
operation should adjust these settings.
Improper settings of these features may
cause damage to this unit not covered
under warranty. To bypass these setting
press.
SCROLL BUTTON
until the display reads
E
E
x
x
i
i
t
t
Then press
DOWN BUTTON
.
The
display should look as follows:
8
8
:
:
0
0
0
0
A
A
M
M
1
1
0
0
0
0
0
0
G
G
L
L
Valve Regeneration Set-up
6. Backwash.
The display should be
:
B
B
A
A
C
C
K
K
W
W
A
A
S
S
H
H
:
:
"
"
1
1
0
0
"
"
m
m
i
i
n
n
The number displayed may vary depending
on the model and pervious programming.
This mode may not be available under
certain conditions
The backwash time can be programmed from
1 to 99 minutes. The Backwash cycle is used
to remove particulate matter that is
mechanically trapped and restratify in the bed.
Use the:
UP BUTTON
DOWN BUTTON
to change the time that the unit will normally
backwash during regeneration. Pressing the
SCROLL BUTTON
again moves you the next setting
7. Brine and Rinse:
The display should read:
B
B
R
R
N
N
/
/
R
R
N
N
S
S
:
:
"
"
6
6
0
0
"
"
m
m
i
i
n
n
The number displayed may vary depending
on the model and pervious programming.
This mode may not be available under
certain conditions
The Brine and Rinse cycle is the time when
the brine is drawn into the unit and rinsed to
drain. The Brine and Rinse time can be
programmed form 1 to 99 minutes.
Decreasing the length of this cycle may cause
brine to remain in the bed after regeneration.
Care should be taken when adjusting this
cycle.
Use the:
UP BUTTON
DOWN BUTTON
to change the time that the unit will normally
Brine and Rinse during regeneration. Pressing
the:
SCROLL BUTTON
again moves you the next setting.
8. Fill and Rinse:
The display should read:
F
F
I
I
L
L
L
L
/
/
R
R
N
N
S
S
:
:
"
"
5
5
"
"
m
m
i
i
n
n
The number displayed may vary depending
on the model and pervious programming.
This mode may not be available under
certain conditions
This Cycle performs two important functions.
1. Controls the amount of water used to
make the brine solution for the next
regeneration.
2. Rinsing and repacking the bed before it is
returned to service.
Adjusting this cycle may result in changing the
amount of brine used during regeneration and
so care should be taken with this adjustment..
The Fill and Rinse time can be programmed
from 1 to 99 minutes. Use the:
UP BUTTON
DOWN BUTTON
to change the time that the unit will normally
Brine and Rinse during regeneration. Pressing
the
SCROLL BUTTON
Summary of Contents for 2401 Series
Page 1: ......
