Water Softener
Page 6 of 18
Setup
Unpacking and Inspection
Check the
WATER DOCTORS
system components for damage or missing parts.
Where to Install the Softener
Consider the following points when determining where to install the water softener:
Place
the
WATER DOCTORS
system as close as possible to a sewer drain.
Do not install the softener where it would block access to the water heater, or access to the main water
shutoff, water meter, or electrical panels.
Keep outside faucets on hard water to save soft water and salt.
Install the softener in a place where water damage is least likely to occur if a leak develops.
A 120V electrical outlet is needed to plug in the transformer. If the outlet is remote (up to 100 feet), use 18
gauge wire to connect.
Always connect the
WATER DOCTORS
system to the main water supply pipe before the water heater.
Install
the
WATER DOCTORS
system where it will not be subject to temperatures outside of the limits
stated in the Specification section or to direct sunlight.
Hardness Setting
Municipal Water
WATER DOCTORS
recommends that you call your local water company to determine your water hardness in
grains per gallon and iron in mg/l (or ppm).
Well Water
WATER DOCTORS
recommends that you have your water tested professionally for accurate hardness and iron
content.