Start-Up Procedure
Fill the mineral tank with water:
Press and hold the extra cycle button for 5 seconds. Dis-
play will indicate step 1, which is the backwash cycle (as shown above). Once the display
indicates step 1, slowly open bypass valve and let water run to the drain for approximately 5
minutes. This will bleed any air from the system and flush it to the drain. After approxi-
mately 5 minutes, manually index the valve through the remaining cycles as follows:
Push the extra cycle button
once to advance the valve to regen step 2
Push the extra cycle button
once to advance the valve to regen step 3
Push the extra cycle button
once to advance the valve to regen step 4
At regen step 4, allow the control to automatically complete step 4 (brine refill) and return to
service. This will place the correct amount of water in the brine tank for start-up.
The unit is now pressurized with water and ready for service
.
Proceed to setting current time of day.
Placing unit into service
