4
Start-Up Procedure
1. Fill the mineral tank with water
Keep NitraMAX in BYPASS
Press and hold the extra cycle button for 5 seconds, display will indicate BW, Backwash
cycle.
Push extra cycle button once and let go, display will indicate BD, Brine Draw cycle.
Push extra cycle button again and let go, display will indicate RR, Rapid Rinse cycle.
Slowly open bypass valve and allow water to flow for 2-4 minutes. This will allow the
media in the tank to become saturated.
Open bypass valve to the service position.
Push extra cycle button once and let go, display will indicate BF, Brine Fill cycle.
Allow timer to fill the brine tank for the entire time on the display. The unit will advance
to the service position when completed.
Push extra cycle button for 5 seconds, this will start a manual regeneration from start-to-
finish. This will take approximately two hours.
Start-up procedure is now complete.
The unit is now pressurized with water and ready for service
.
Proceed to setting current time of day.
Placing unit into service
Normal
Operation
Mode Icon
While in service, the Data Display alternates between time of day,
volume remaining or days to regeneration.
The Flow Indicator flashes when outlet flow is detected.
The Faucet Icon flashes if a regeneration cycle has been queued.
