9) When controlling the motion detection function, c onnect to
⑩
I/O
CONNECTOR after wiring using the attached cable. See the pin
configuration as follows.
PIN No.
Cable color
Title
Function
1
Brown
MD_O
Alarm out
2
Black
GND
Camera GND
3
-
NC
■
Alarm output terminal
When the motion detection function is used, the alarm output terminals
1 and 2 are hot during detection of movement in the monitored area.
If an LED is connected as shown in the diagram below, the alert turns
on the LED by voltage output of 3.3V at maximum current of 6mA.
Options
To purchase these options, please contact the distributor or dealer from
which you purchased the WAT-910HX/RC.
Contact information
Contact information
Watec Co., Ltd.
Add.:
I
254-2 Nihonkoku, Daihoji, Tsuruoka- Shi,
Yamagata-Ken, 997-0017 Japan
TEL: +81-235-23-4400 FAX: +81-235-23-4409
E-mail: [email protected]
URL: http://www.watec.co.jp
•
Design and specifications are subject to change without notice.
•
Watec is not responsible for any inconvenience or the attendant damages
to the video and monitoring recording equipment caused by misuse, mis-
operation or improper wiring of our equipment.
•
If for any reason the WAT-910HX/RC does not work properly, or if you
have any questions regarding installation or operation, please contact the
distributor or dealer from which it was purchased.
※
Mimimum illumination specification applies to cameras with serial
numbers from W154BE01001/W154BC01001 and higher.
C-mount Adaptor (30CMA-R)
This lens mount adaptor is used
to convert a CS-mount to a C-
mount.
Mini Stand (MS50)
A convenient stand for the
WAT-910HX/RC. With this stand,
the camera can be adjusted to
any desired angle.
1542Z00-Y2000013
