Copyright© 1998 - 2013 WatchGuard Technologies, Inc. All rights reserved.
WatchGuard, the WatchGuard logo, LiveSecurity, and any other mark listed as a trademark in the “Terms of Use” portion of the
WatchGuard Web site that is used herein are either registered trademarks or trademarks of WatchGuard Technologies, Inc. and/or its
subsidiaries in the United States and/or other countries. All other trademarks are the property of their respective owners.
Revision date: April 12, 2013
Part Number: 369-4554-001 Rev A
4
WatchGuard XCS 1180 — Rack Mount Kit
Attach the Outer Rails to the Rack
Use this procedure to mount the outer rails to the rack.
1. Use two rack screws and washers (not included) to connect the front bracket on the outer rail to the
front post of the rack. The outer rail is typically seated on the inside of the rack post.
Make sure that the sliding piece is toward the front of the rack and faces the center.
2. Extend and adjust the rear bracket depth to match the depth of the rack.
3. Use two rack screws and washers (not included) to connect the rear bracket to the rear post of the rack.
4. Repeat these steps to attach the other rail to the other side of the rack.
