Installation
Note: If the tamper switch is not switched on, the siren will not work properly.
1. Choose the mounting location for the siren - the wall must be even and not have any
holes or protrusions.
2. Open the siren housing and mount it to the wall with the 3 included screws.
3. Connect the wires to the terminal
(refer to Wiring Diagram)
and plug the terminal to your
drive board.
4. Power on the system and check that it’s functioning properly, then connect it to the
backup battery.
5. Close the housing, ensuring the tamper switch is pressed down as you do so.
6. If powered correctly, all 3 LED lightss will flash on for 5 seconds then turn off.
