4
WatchGuard Firebox T30 / T50
Hardware Specifications
Mode
The Mode indicator shows the status of the external network connection. If the device can connect
to the external network and send traffic, the indicator is green. The indicator flashes if the device
cannot send traffic to the external network.
Attn
The Attn indicator is yellow when you start the device with the Reset button pressed. For more
information, see “Restore Factory Default Settings” on page 9
Power (
)
The power indicator is green when the device is on.
Rear View
Rear panel of the Firebox T30.
Rear panel of the Firebox T50.
Network interfaces
The Ethernet interfaces have standard RJ45 connectors and support link speeds of 10, 100,
or 1000 Mbps. On each model, the highest numbered interface is a PoE (Power over Ethernet)
interface, compliant with the IEEE 802.3at standard.
o
On the Firebox T30 and T30-W, these interfaces are labeled 0/WAN, 1/LAN, 2, 3, 4-PoE.
o
On the Firebox T50 and T50-W, these interfaces are labeled 0/WAN,1/LAN, 2, 3, 4, 5, 6-PoE.
USB interfaces
The device includes two USB interfaces. Connect a USB storage device to use for USB backup and
restore, or to store a support snapshot. For more information, see the current
Fireware Help
.
Serial port (Console)
An RJ45 connector for the serial interface. An RJ45 serial cable is not included with the device.
Power switch
Controls the power supplied to the device. Move the switch to position
1
to power on the device, or
position
0
to power it off.
Power input
An AC power adapter is included with your device. Connect the AC adapter to the device and to a
power source. The power supply tip is plus (+) polarity. Use only the supplied AC power adapter.
Reset button
To reset the device, use the procedure in “Restore Factory Default Settings” on page 9.
