WatchGuard Firebox T20/T20-W Hardware Guide
AC Power Adapter
The AC power adapter supplies power for the Firebox. The power supply connector has a screw-type
retention mechanism. To prevent a disruption in the power supply, tighten the screw on the connector.
Before you connect the adapter, verify that the color band on the cord matches the color ring around the
power plug on the Firebox.
To safely connect the power supply:
Insert the silver connector on the power cord into the power port on the Firebox. Tighten the screw
until the connector is securely attached to the Firebox.
A T20 Firebox shipped outside the United States includes four power plugs to connect to the AC power
adapter. Use the correct power plug for the power source used in your country.
Wall Mounting Plate
The wall mounting plate (available separately) enables you to mount the Firebox on a wall in a good location
to increase the wireless range.
You need four screws 1/8" (3 mm) wide and at least 3/4" (18 mm) long to install the mounting plate.
To install the wall mounting plate:
1. Place the wall mounting plate horizontally against the wall where you want to install the Firebox.
2. Securely screw the wall mounting plate to the wall with the four screws.
3. Align the two holes on the bottom of the Firebox with the two connection points on the mounting plate.
4. Push the Firebox toward the mounting plate, until the two connection points on the mounting plate are
inside the holes on the bottom of the Firebox. Then press firmly down to seat the device on the plate.
To remove the Firebox from the mounting plate, push the Firebox up slightly, and then pull out, to separate
the connection points on the mounting plate from the holes on the bottom of the Firebox.
WatchGuard Technologies, Inc.
ix
