Before
starting the unit, connect up the following:
To install the
rinsing water connector
, you'll need a pressure hose with woven liner
measuring 0.5 inch (13 mm) in diameter, and for the
drain
, a plastic hose 1 inch (25 mm)
in diameter. When installing the drain hose, make sure that the hose end hangs freely in
the plaster separator and not beneath the surface of the water.
7.3
Rinsing Water Hose
Before
the woven hose is connected to the device, please turn on the tap for a little
moment, so that any dirt in the water line is flushed out. Otherwise, correct water
supply to the unit may be affected.
Subsequently install the flushing-water connector (pressure hose with woven liner)
between the tap and the hose connector on the unit. This connector is located at the rear,
underneath the motor. Use the clamps already mounted on the hose and tighten them
firmly. The tap must have a cut-off valve so that the feeder hose does not remain under
constant pressure when the unit is not being used.
Retighten the hose clamps about 2 days after installation.
Be sure to turn off the tap overnight and at the weekend.
7.4
Drain Hose
The drain hose must be laid out such that water can never back up in the trimmer. This
would cause the water to spray out through the grinding disc opening. Always arrange the
hose in a smooth bend (not kinked) and with a permanent drop of at least 1 cm per metre.
The end of the drain hose must be above the water level of a plaster catcher.
The hose end must not be immersed in the water.
If necessary, shorten the hose.
In its standard configuration, the drain-hose connection is angled off to the right.
Finally
, insert the power plug into the socket, making sure that the mains and the unit
operate on the same voltage.
9
