Before
starting the unit, connect up the following:
6.2
Rinsing Water Hose
Locate the rinsing water hose (thinner hose with woven insert) between the tap and the
hose connector on the trimmer. This connector is at the rear, under the motor. Use the
clamps already on the hose to connect it, tightening them securely.
There should be a stopcock between the tap and the feed hose so the hose is not under
continuous pressure when the trimmer is
not
being used.
Tighten the hose clamps again about 2 days after installation.
The tap must be turned off at night and over the weekend.
6.3
Drain Hose
The drain hose must be laid out such that water can never back up in the trimmer. This
would cause the water to spray out through the grinding disc opening. Always arrange the
hose in a smooth bend (not kinked) and with a permanent drop of at least 1 cm per metre.
The end of the drain hose must be above the water level of a plaster catcher.
The hose end must not be immersed in the water.
In its standard configuration, the drain-hose connection is angled off to the right.
Finally
, insert the power plug into the socket, making sure that the mains and the unit
operate on the same voltage.
9
