Wassermann Dental-Maschinen WSM-2, User Manual

Page: 7 / 12

5
Installation / Start-up
Before starting the unit, connect up the following:
5.1 Installing the brush spindles
To use the polishing motor, you have to install the brush spindles, and that involves first
removing the nuts. Use a cloth to clean the shaft ends and then replace the nuts.
Use compressed air to remove dust and grime from the brush spindles, then install the
spindles as marked: L = left and R = right . Use a hammer and a piece of plastic to tap the
spindles onto the end of the taper.
Excessive force could damage the ball bearings and void the warranty.
The spindles must run true when the motor is on. If they do not, repeat the above steps.
Finally , insert the power plug into the socket, making sure that the mains and the unit
operate on the same voltage.
6
Operation
6.1 General operating instructions
All instructions for using the unit, whether in verbal or written form, are based on our
own experience and experimentation and can only be regarded as guidelines.
1. Connect the polishing motor to the mains.
2. Use the toggle switch to select the speed.
7