30
WPL 406 User Manual
Offset
+000
Shift Y
+000
Cutter Mode
Enable the cutter mode.
Cutter Batch
Cut the media once at the end of the printing job.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-1.5 Offset:
Print Setup
5/12
Direction
Print Mode
>
Offset
This option is used to fine tune media stop location for peeler and cutter mode. Press the
button to move the cursor from left digit to right digit, and press the
button to set the value from “+” to “-” or “0” to “9”. Press the
button to set the
value into printer. Press
key to cancel the setting and return to the previous
menu. The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send out the
OFFSET command, which will overwrite the setting set from the front panel.
3.1.1-1.6 Shift X & Shift Y:
Print Setup
7/12
Offset
Shift X
>
Shift Y
This option is used to fine tune print position. Press the
button to move the
cursor from left digit to right digit, and press the
button to set the value from “+” to
“-” or “0” to “9”. Press the
button to set the value into printer. Press
key to cancel the setting and return to the previous menu. The default value is +000.
Note: If printing from enclosed software/driver, the “Use current printer settings”
option is enabled, software/driver will not send out the SHIFT command to
overwrite the settings set from the front panel.
