Chapter 5
Scanning Modes, Country Codes
*Default
00 Default*
04
Continuous
00 USA*
06 Portuguese
01 Belgium
07 Spanish
02 Danish
08 Swedish
03 France
09 Switzerland
04 German
10 UK
05 Italian
11 Latin America
14
Begin
Set Scanning Mode
Exit
Begin
Keyboard Layout
Exit
The 'Scanning Mode' option controls the trigger and LED settings for the WLP
4170 CCD Scanner.
Note:
For help in configuring these settings, consult the programming steps on
page 5.
Continuous Mode
* Trigger with 10 Sec. Delay
When this option is selected, the LEDs are visible at all times. Under this option,
you cannot read the same bar code back-to-back.
This is the default option for the Wasp WLP 4170 CCD Scanner. When this option
is selected, the scanner will stop scanning when there is a successful read or no
code is scanned after 10 seconds.
Scan “Begin” at left, then scan the “Keyboard
Layout” at left. Pick a country setting from the
table below, then turn to the back cover flap and
scan the corresponding two digits. Scan “Finish”
on the back flap, then scan “Exit” below.
