Page 20 of 41
© 2003 Wasp Technologies, Inc.
Online
Use the [ ] key to toggle between REMOTE and
LOCAL, then hit [ENT] to make the selection.
REMOTE
The WDT2200 will output data gathered
from the bar code port or keypad to its RS-232 port.
LOCAL
The WDT2200 does not transmit gathered data to its RS232 port.
Echo
Use the [ ] key to toggle between ON and OFF, then press [ENT] to make the
selection. The collected data will be displayed on the WDT2200 LCD when
Echo
is
set to ON, otherwise data will not be displayed when it is set to OFF.
AutoLF
Use the [ ] key to toggle between ON or OFF, then hit [ENT] to make the
selection. When
AutoLF
is set to ON, the WDT2200 will append a LF (10 hex)
character to the input data block.
Mode
Use the [ ] key to toggle between BLOCK and CHAR, then hit [ENT] to make the
selection. See section 3.2.2 for the description of
Block
and
Character
modes.
Line/Page
Use the [ ] key to toggle among LINE, PAGE and BOTH, then hit [ENT] to make
the selection.
The
Line/Page
parameter is useful only if dumb
terminal operation
has been
specified as BLOCK mode. The
Line/Page
entry designates the termination
character. The termination character can be set as:
LINE
Line termination: CR ( 0D hex)
PAGE
Page termination: CTRL-Z ( 1A hex)
BOTH
Line termination and page termination
3.2.3.3
Memory Configuration
This feature allows the user to allocate available RAM between the Execution Program and RAM
disk area, and
can only be done when there is no data stored in RAM
.
The RAM memory in the WDT2200 is divided into three sections:
♦
System Variable
About 29KB of RAM memory is reserved for WDT2200 parameters.
♦
RAM Disk Area
Area used to store programs and data files, similar to a physical disk of a
PC.
♦
Program Execution
Area where the applications and data are loaded, similar to the main
Area
memory in a PC.
<<TERM SETUP>>
ONLINE
REMOTE