Wasp DELTA 4070, Manual Of Use And Maintenance, Page: 55 / 88

P
remises
© WASP S.r.l.
55
USE OF THE PRINTER
8 USE OF THE PRINTER
8.1. Adhesion to the bed
The adhesion to the plate takes place during the deposition of the first layer and is essential for the success of
the printing.
The fundamental points of a good adhesion are:
• Correct leveling of the printing bed
• Adhesive glue (chosen based on material)
• Correct speed and flow in the first layer
• Adequate printing floor temperature (PLA 40 ° C, ABS 100 ° C)
If the spillage of the material is particularly scarce or even absent, check
• The extruder is not clogged with a manual extrusion
• The extruder does not print too close to the plane (preventing extrusion during the print)
• The extruder temperature is actually the one needed for the material in use
It is recommended to make sure that the adhesion between first layer and bed.