Wasp DELTA 4070, Manual Of Use And Maintenance, Page: 46 / 88

fig 7.3.1 c fig 7.3.1 d
P
remises
© WASP S.r.l.
46
Ordinary and extraordinary maintanance
REMOVING EXTRUDER BLOCK FROM ZEN EXTRUDER
1. WIth machine turned on use “Autohome” command from menù PRINT>AUTOHOME
2. Perform the removal of the filament as describer in paragraph 5.3 “First start”
3. Turn off the machine
4. Remove the velcro band
5. Remove the PTFE pipes by pushing down the crowns and pulling up the pipes
6. Unplug the connector
7. Remove the OOZE SHIELD as described in paragraph 7.2.6 “Replacing Ooze shield protection”
8. Unscrew and remove the two central-external fixing screws when holding with strenght the extruder block
itself
9. Remove the extruder block from the extruder carter